How To Speed Up PTCL Internet Connection
Broadband commonly faces up infrastructure issue at CPE, ( customer Premiss’s Equipment) or DP (Distribution Point) from where the phone line extends to the subscriber house. Whenever the DP is distant an your wires are entangled with clustering of additional communicating & electric, cable television set cables, you most likely will experience SNR (signal/noise ratio) Lower then required. Briefly your Teleline is being influenced by other active electromagnetic interventions.
Whenever yours Telewire comprises by these kind of infrastructure, then your Internet shouldn’t have worked in the First place 🙂
SNR & Line Attenuation
SNR is ratio of functional data-signals on your line & Attenuation is the decrease in signalise effectiveness on your telephone line. You will be able to check out your SNR & fading in your ADSL Router by going to the main status page of DSL routing via IP address (192.168.1.1 in case of PTCL Router).
The Ideal SNR Ratio
6dB or below is bad & will disconnect again & again
7dB-10dB is fair but is not stable in different conditions
11dB-20dB is good
20dB-28dB is excellent
29dB or above is outstanding
The Ideal Attenuation
20dB and below is outstanding
20dB-30dB is excellent
30dB-40dB is very good
40dB-50dB is good
50dB-60dB is poor and may experience connectivity issues
60dB or above is bad and will experience connectivity issues
So lets Resolve it now.
Note (This Setting is for ZXDSL 831CII Router, But applies to Most of the DSL Routers)
1. If your telephone line is old an has cut’s or joints in places, it is suggested to purchase a new cable with higher gage to substitute it, i.e from DP to your Home
2. Make sure the cable isn’t lengthier then compelled, additional length brings down your signaling ability
Erstwhile the ADSL Spliter (Filter) isn’t adequate to the caliber, either purchase new or bump off Filter if not necessitated
3. Link up your computing machine or Laptop to the ADSL Router via RJ-45 cable via ur local area network Card.
4. Open your IE (Internet Explorer) & Type 192.168.1.1 (just in case your default IP address addres of the Router isn’t modified)
5. In that page, go to Advance settings, an on left Column you will see, ” ADSL” Select that an from the ADSLMode drop down menu choose G.DMT as your ADSL mode.
6. Click save & Reboot your Router)
For Better Browsing Experience
- From Taskbar right click your Network Adopter properties & click on TCP/IPv-4
- leave the IP on obtain Automatically but select use following DNS. Enter Primary DNS: 220.127.116.11 & Secondary DNS: 18.104.22.168
Hope fully you will see 50% plus speed boost after this …….